We've developed a great solution for "punch out". When you drill through a stone from one side the opening at the other end most often chips or fractures. This is called "punch out". The way to solve this is to drill halfway from one side then flip the stone over and finish the hole from the other side. The challenge is aligning the holes so that they meet in the middle and remain centered in your stone. We have developed a self-centering system that automatically aligns the holes and ensures a centered hole every time.
The key to this system in the counterpart, which is a post that has the same diameter as your drill bit. This counterpart is aligned under the drill bit in the magnetic base, and the item to be drilled is then laid on the counterpart. You drill halfway through the stone then flip the stone over and put the hole onto the post. Your stone in now perfectly centered and ready to drill through the other half. The drill will meet in the center every time.
The counterpart must be the same size diameter as the drill bit that your using to ensure a perfect alignment. Therefore, you will need to purchase a corresponding counterpart every time you purchase a new drilling bit size, but once you have the counter part for that bit size you can use it over and over again for many drill bits.
These standard sizes are kept in stock and we anticipate a two-day turnaround for delivery. If we are on back order we will immediately notify you of any delay If you need a specific size that is not listed here please see our Custom Size Counter Part options.
For questions or any additional special orders, please contact us by email at kevin [!at] guntherdiamondtools.com, or by phone at (520) 314-9809.