These decals have self adhesive backing that will stick to most clean flat surfaces including laptops, furniture, vehicles and interior walls. These decals are made from premium commercial grade vinyl and are laminated to lasts for years to come.
Decal is sized to fit Sides of TJ tub
Listing is for QUANTITY OF ONE DECAL.
+Special Sizes and Colors available upon request
Check out our Etsy store or website www.decalgorilla.com for more vinyl decals!
All items purchased from the Site are delivered pursuant to a shipment contract with the carrier of our choosing. The risk of loss and title for such items will pass to you upon our delivery of your order to the carrier. Any shipping damage should be reported at the time of delivery to the shipping company. If special packaging is required for proper shipping, you will be charged accordingly.
Returns & exchanges
Understandably, personalized and decal items may not be returned for a refund.
we will use reasonable efforts, upon your request, to change or cancel your order prior to production. If the order has not yet started the production process, no additional change or cancellation fees will be applied. If your order is changed, setup fees may occur and may alter your original quote depending on your requirements.
If the order has reached the pre-production set up phase, there may be cancellation or change charges that apply. If your order is changed, the setup fees may vary from the original quote depending on your requirements.
If an item has begun production, unfortunately, we cannot stop or change the order. We can, if you wish, prevent shipment or redirect it. You will be charged the full amount of the order for all orders canceled at this stage.
We do not issue refunds on ANY decals. If there is an issue with the decal please contact us. We may replace the decal but this is on a case to case basis.
Installing a decal is not a science, But does take some knowledge. Please read the following to install a decal.
Step 1- Verify that the area you are looking to add your decal to is suitable for a decal, Ensure the surface is smooth and free of any texture. Glossy areas are typically the best substrate to apply decals too. Decals will not adhere to some plastics.
Step 2- Clean the substrate. Make sure the area you would like to install the decal on is free of any oils, waxes, dust and dirt. One of the best ways to clean an area is with Isopropyl alcohol. wipe clean and let area dry. If an area is heavily soiled a second cleaning with alcohol is recommended
Step 3- Install the decal. fully peel the decal off the backing (white paper) and hold it on the tips of the masking/transfer tape. Try not to touch the back of the decal itself since it could leave dirt on your decals back side. You should have each hand holding the furthest corners from each other and keep it tight so that the decal does not fold in on itself. Place one end of the decal down and then smooth it out to the other end till the decal is fully placed.
Step 4- Smoothing and removing bubbles- Once the decal is placed on the substrate , use a credit card or hard squeegee to remove any bubble and ensure the decal is fully contacting the substrate.
Step 5- Removing the transfer tape- This is the finishing and last step to apply a decal. There is a clear/semi clear tape over top of the entire decal. This is a material used to only apply the decal and SHOULD NOT be left on. Pull up the edge of the transfer tape and slowly remove pulling the transfer tape back onto its self. Is the decal is coming back off with the transfer tape STOP! push the transfer tape back down into place and re-squeegee the area, depending on the conditions or substrate heat may need to be applied. A hair dryer will work perfect for this. Apply heat and begin to slowly remove the transfer tape off of the decal. Once the transfer tape has been removed your installation is complete.