Professional hotfix applicator work on most types of crystals/studs/nailheads!
Ergonomically designed handle. Comfortable rubberized grip. On/Off switch for more convenient. Heats up in 2 minutes. Universal voltage: 110 V / 220V / 230V / 240V. Work anywhere in the world, so please feel free to buy! If the plug can't use in your country, please feel free to inform me about this, I will send one power plug converter adapter for free.
Includes 7 precision interchangeable tips. Sizes of 7 tips: ss6 = 2mm, ss10 = 3mm, ss16 = 4mm, ss20 = 5mm, ss34 = 7mm, 4mm flat hot spot, 9mm flat hot spot.
Dimension: 18.5 x 4 x 2.6cm. Cable: 108cm length.
How to use: 1. Choose the correct size applicator tip for the stone size. If not sure the size, place the tip over the stone. The correct size tip will pick up the stone. The flat tip is uses for flat stone that don't fit into the round tips. Screw in the correct size tip when the applicator is cold! 2. Plug in the applicator wand and switch it on. Leave for about 2 minutes. 3. With a stone facing faceted side up, place the tip over the stone and pick it up. Do not press hard, the stone may stick to the suface. 4. Watch the glue till it starts looking wet. Now the stones is ready to be applied to the surface. It will take about 5 seconds or more, depending on the size of the rhinestones or stud. 5. Press the applicator lightly at 90 degrees celsius to the surface. Move the applicator up and away. In case the stone gets stuck in the tip, use a pair of tweezers and push downwards through the slit in the tip to get the stone out. If the stone hasn't bonded correctly, place the tip over the stone for a couple of seconds to melt the glue again.
Caution: be careful! The applicator and stones will be hot so do not touch them with your fingers!