Hand forged steel angle brackets. These are heated and bent by hammer and anvil - not in a brake press. Since they are hand made very slight variations are to be expected.
***LISTING IS FOR ONE BRACKET****
- 1/4" flat bar - avaliable in 1, 1.5 and 2 inch widths - Choose Bracket Size from drop down - 2 countersunk holes in the vertical bar - 2 countersunk hole in the shelf support - Hardware included - Raw Steel finish
Shipping is the same for 1 - 10 brackets. Please send a convo for larger orders.
*MOUNTING BRACKETS: Brackets should be installed into wall studs when mounting.
Table Legs ship via UPS Standard ground 1-6 days transit Continental US Visit our transit time map for table legs: https://www.pinterest.com/pin/289637819764396173/
Brackets via USPS Priority mail 1-3 days transit Continental US and HI and AK
- We will forward tracking numbers for your convenience once your order ships. - We do not require a signature upon receipt. This service is available upon request.
You are welcome to pick up if you're local to NH!
We accept the payment methods provided through Etsy.com.
Returns & exchanges
I don't accept returns, exchanges, or cancellations
But please contact me if you have any problems with your order.
Additional return information
Every item is made custom therefore we can't accept returns. Canelations may be accepted if materials have not been purchased and/or fabrication has not yet begun. Please message me directly.
MOUNTING BRACKETS Brackets should be installed into wall studs when mounting. Each installation is different. While these are 1/4" steel brackets, we cannot advise on a specific load weight given the variety of installation options, board widths, lengths and specific customer usage. Please use good judgment or if you are unsure of how to properly install them, please consult a contractor.