1/2" inch coin ring center punch set made from O-1 tool steel and heat treated for maximum durability.
Included 35 piece ABS plastic 3D printed spacer set. Spacer inner diameters range from 20 mm to 36.5 mm in 0.5 mm increments. For coins that fall in between spacer sizes, use a small piece of paper towel to "shim" the coin into the spacer for a perfect center hole punch.
This punch has a maximum inner diameter of 39 mm and fit's 1 ounce copper rounds without a spacer. Fit's Silver dollars with minor shimming. With the included spacer set, you can punch 1/2" inch center holes in hundreds of different coins, both foreign and US.
This is a quality coin ring punch, made in the USA by American craftsmen, and made to last.
This center punch and spacer set is in stock and ready to ship USPS Priority Flat Rate Mail with Signature confirmation within one business day.
International buyers, contact me for shipping quote.
Thanks for looking at my listing, Karen.
I combine shipping when possible and refund shipping overages.
No coins are included with this listing.
These printed spacer sets may have the occasional rough edge or micro filament of plastic residual left over from the 3D printing process. If you find any irregular edges on your spacers, a light touch of sanding with 500 grit sandpaper (included) will clean up any minor issues.
I recommend that every coin ring maker purchase a micrometer and check the diameter of the coins / rounds that they are using. Many copper / silver rounds vary in diameter, depending on the manufacturer.