3d Printed Majora's Mask Cookie cutter and Stamp
Available in 3" and 5" sizing. This is a very detailed piece, and thus includes an outline cutter AND stamp to make it easier to remove the dough from the cutter.
IS NOT DISHWASHER SAFE - PLA plastic becomes malleable at about 60 degrees Celsius (~140 Fahrenheit), so you can hand wash with warm water, but I don't recommend prolonged exposure.
I've been a major fan of Majora's Mask since I was young, and jumped at the chance to make AWESOME cookies shaped like the mask itself.
Great for proving that you're cooler than all the other Zelda Nerds around.
Roll cookie dough 1/4-3/8" thick (thinner dough spreads less and holds detail better.)
Firmly press the stamp into the dough until desired depth (more depth gives greater detail.)
Remove stamp (lightly jiggling makes it come out cleaner.)
Line up the outside edges of the impression with the outline cutter, and press until clean through.
Special Thanks to miguelangellv on Thingiverse for the design.