This is a complete gravity fed water drip kit for either the electroplated steel discs or the soft flexible polishing pads. It contains everything you need to set it up to deliver a steady clean drip of water to the wheel or disc. Just drill a 7/8 inch (preferred) or 1-inch hole in a 5-gallon bucket or other plastic containers, bolt on the plastic spigot, push on the flexible silicone rubber tube, and attach one or all of the three hose clamps as needed, and adjust the length of the nozzle to the center of the wheel. The spigot should be above the level of the copper/plastic nozzle. See a brief ( 4 minutes) video on YouTube for a demonstration of the entire line, showing the water drip system in action: (copy and paste) https://www.youtube.com/watch?v=K2eTCi-CLos&feature=youtu.be
Included are: One Spigot two plastic "nuts" two silicone rubber washers 3-foot length of flexible, high quality 3/8 inch ID silicone rubber hose with 1/8 inch thick walls 8-inch plastic and copper adjustable length nozzle 3 types of hose clamps, two can be bolted onto the edge of the splash pan by drilling 1/8” or 1/4”holes or use your imagination
Also suitable for dripping water for Lapidary or any other water based grinding.
This works beautifully and was just what I needed. It was very easy to set up by following Ray's instructions. Thank you!!