Bare Naked Brew Stand

Sold by TexasMetalWerx
+ $1.00 shipping
+ $1.00 shipping
Made to order
Preparation takes 1-2 weeks
Arrives from the United States


Item details

Here is our Bare Naked stand for the brewer wanting to build as his budget allows. All the fabrication and welding is done for you and save another hundred bucks over our "Brewstand Without Burners" by painting the stand yourself and adding casters.

You will receive a parts and sources list for everything we use on our ready to light stands.

This stand utilizes the most common three vessel HLT, Mash Tun, and boil kettle brewing method. There are two pump mounts with splash guards. Mounting plates will accept March or Chugger pumps.

The front lower frame member functions as a gas bus like the Brutus Ten design. This bus is all TIG welded and tested to 100+ PSI as a unit before being welded into the stand.

The stand works great with converted beer kegs or "keggles" (I can supply these) or other kettles up to 25 gallons each. Note that if using flat bottom kettles our burner grates are needed to allow for burner ventilation. Not required when using keggles.

The stand is 60" long, 15" deep. and 27" tall.

IMPORTANT SHIPPING NOTES -- The $1 Shipping cost shown is only there to prevent Etsy from showing "FREE SHIPPING." Actual shipping will apply once determined.

I have had good luck using I can handle this at my end. The key to getting a great deal on is to be patient and flexible. You will need to wait until a carrier who is already going your way comes along. Usually 3 to 5 days. I have shipped brew stands to New York, Los Angeles, and Portland OR for around $200.

*** Because UShip requires payment in order to book the shipment I will pay for shipping and then send you a request for reimbursement through Google Pay.

    No reviews yet

Shipping & policies
Preparation takes 1-2 weeks
Arrives from the United States
Estimated Shipping
Shipping to
Zip or postal code