**please make sure your printer is using the same main board as shown in the guide(link below) and pic 4** edit** v2.1 board also supported.
This kit is for the CR-10s - CR-10s s4 - CR-10s S5 - CR-10s Mini, which come equipped with the ATMEGA 2560 board as show in the download. IT IS NOT FOR THE CR-10 or any of the printers with the Melzi board.. please make sure you check before buying!
This version is different to my usual Cr10 kit in that it does not contain the bootloader flashing tool or the sensor mount. This is because you dont need the bootloader tool for the cr10s machines and this also helps me save on postage and get the cost down for the end user.
This listing Contains;
1x 18mm Capacitive Probe (1-10mm adjustable sensing distance) Mounting hardware - 2x 18mm nuts and washers 1x level shift chip by XYGAX- Pre-Soldered making this sensor fully PLUG AND PLAY.
This sensor is fully compatible with the th3d unified firmware and performs identically!
full instructions and firmware can be downloaded here;
i take no responsibility if you decide to modify your printer from its stock form. you do so fully at your own risk. I'm here to provide support should you need it and all my kits are tested fully before dispatch so if for some reason you brick or blow up your printer or whatever.. on your head be it. Do not attempt to modify your machine if you are not confident in doing so.. and also please do not attempt if you don't have basic knowledge of using your printer in its stock form!