Step 1: Thread needle through pom pom
Choose the two pom poms that you want to use to make your earrings. Cut approximately 2 ft. / 60 cm. of thread and thread your needle. Push your needle through the center of one of the pom poms, leaving a long tail.
Step 2: Thread needle through bar connector and back through pom pom
Next, thread the needle through one end of your bar connector and push your needle back through the center of your pom pom to meet the tail end of your thead. Pull on the thread so the end of the bar connector is resting up against the pom pom.
Step 3: Repeat, repeat
Repeat Step 2 twice, or until your pom pom feels securely attached to your bar connector.
Step 4: Knot thread and trim excess
Tie the ends of your thread using a double knot. Trim excess thread.
Use both pairs of your pliers to open a jump ring. Next, slide the jump ring through the top hole of the bar connector. Add the ball earring post. Close the jump ring.
Step 6: Repeat process to make second earring
Repeat steps 1-6 to make your second earring.